The right wood transition strip will match the color of the flooring. Step 3: Install Starter Strips & Trim. Live chat: Chat with an Expert. Sand the bottom of the reducer and place patches of glue roughly every 6-inches. An example would be a tile to wood floor transition strip. Files (0) Drop Files. T-molding transition strips have two lips to cover the edges of both surfaces, when flooring products differ no more than about 3/8-inch in height. Vinyl to Tile Floor Transition Tips. Transition strips do not bottom out; the leg of the "T" doesn't touch the floor. Accessories - Install Vinyl Transition Strips - Install Wall Base - Install Trim & Moldings - Install Stair Treads And Landing Tile - Install Installation. Tip. Be certain to use a reducer with a metal strip and carpet tacks to ensure the carpeting remains stretched and in place. Reducer transition strips work the best to achieve an even surface between carpet and hard flooring. Upload Files Or drop files. If you install end cap molding next to brick, tile or concrete, caulk the gap between the transition strip and the flooring. For this installation method, … Now you’re ready to begin installation of the starter strips and corner posts that receive the siding panels. This article is a continuation of the discussion that began with Step 1: How to Install Vinyl and Aluminum Siding and Step 2: How to Prepare Walls for Vinyl or Aluminum Siding. Install your vinyl floor to within 1/2 - 3/4" of the higher flooring. Wood transition strips: This is the top choice for wood and laminate flooring transitions to another hard surface. Sheet vinyl is a relatively thin flooring type, whereas tiles can be quite thick. The strip is supported on both sides by the lips, and held in place with nails. A vinyl transition strip is also chosen when moisture control is important.